ISSN: 1231-4005

e-ISSN: 2354-0133

2014 | Contents of Volume 21, Number 3:

AuthorTitleDOIPagesPDF
Ambrozik, A.; ...Effect to the Fuel System Type on Energy, Economic and Environmental Indicators of the Spark-Ignition Engine Work10.5604/12314005.11331577-14Full text
Bar, W.; ...Multidisciplinary Design and Optimization of Gas Turbine Engine Low Pressure Turbine at Preliminary Design Stage10.5604/12314005.113315815-22Full text
Brewczyński, D.Non-Contact Measurement of Geometrical Parameters in Landing Gear using the Handheld 3D Laser Scanner10.5604/12314005.113271823-28Full text
Budzik, G.; ...The Influence of Contour Number on Load Carrying Capacity of Gears in Aircraft Gearbox Demonstrator Made by MEM10.5604/12314005.113271929-34Full text
Czaban, A.CFD Analysis of Hydrodynamic Lubrication of Slide Conical Bearing with Consideration of the Bearing Shaft and Sleeve Surface Roughness10.5604/12314005.113315935-40Full text
Czechowski, M.Stress Corrosion Cracking of Welded Joints of Al-Mg Alloys10.5604/12314005.113315441-45Full text
Czekałowski, P.; ...Experimental Analysis of Aerodynamic Performance of Flapping Wings Nano Aerial Vehicles10.5604/12314005.113316147-57Full text
Czyrek, J.; ...An Analog-Digital Hydraulic Cylinder Velocity Control System for Mobile Machines10.5604/12314005.113316459-66Full text
Dereszewski, M.; ...Validation of Reference Sampling for Failure Detection by Crankshaft Angular Speed Analysis10.5604/12314005.113316667-74Full text
Dudzik, K.Properties of Advancing Side of Weld in Joint Welded by FSW10.5604/12314005.113316775-80Full text
Dziewulski, P.; ...Numerical Analysis of the Front Impact between Two Shunting Locomotives10.5604/12314005.113317281-88Full text
Flis, K.; ...Simulation of Pneumatic Motor Used in Pneumobile10.5604/12314005.113317589-96Full text
Garbacz, G.; ...Determination of Yield Point of Structural Materials with Using the Metric Entropy10.5604/12314005.113317697-104Full text
Gawlik, A.Energy Saving System for Off-Road Machines by the Use of the Movable Counterweight Energy Recuperation10.5604/12314005.1133180105-112Full text
Gołębiewski, W.; ...Comparison of the Instantaneous Fuel Consumption of Vehicles with a Different Type of Propulsion System at Constant Velocity10.5604/12314005.1133182113-120Full text
Grab-Rogalinski, K.; ...Cost Analysis of Hydrogen Energy Generation10.5604/12314005.1133183121-126Full text
Haule, K.; ...Optical Properties of Crude Oil Detected in Seawater10.5604/12314005.1133186127-132Full text
Jacyna, M.; ...The Influence of Road Transport on Emission of Toxic Substances in Poland Against the EU Countries10.5604/12314005.1133189133-140Full text
Jakubowski, R.Two- Combustor Turbofan Engine Performance Analysis10.5604/12314005.1133191141-148Full text
Kamiński, P.Determination of a Task’s Validity in the Marine Engine Room Operating Process with AHP Method - Part 2 - Simulation Results10.5604/12314005.1133193149-155Full text
Konarzewski, M.; ...Experimental and Numerical Studies of Selected Types of Batteries – State-of-the-Art10.5604/12314005.1133195157-163Full text
Kończewicz, W.; ...The Prototype Project of the Position to Designate the Screw Thruster Lobe Specific Gravity10.5604/12314005.1133198165-170Full text
Kordel, Z.; ...The Effect of the Road Transport Impact on the Natural Environment in Poland and on the Costs of Road Transport10.5604/12314005.1133200171-176Full text
Kowalski, M.Analysis of an Aircraft Engine Start-Up Process on the Example of the PZL-130 TC-II „Orlik” Training Aircraft10.5604/12314005.1133202177-189Full text
Krakowski, R.Diagnosis Modern Systems of Marine Diesel Engine10.5604/12314005.1133203191-198Full text
Labuda, W.The Influence of Cutting Parameters on Cutting Forces and Surface Roughness10.5604/12314005.1133206199-204Full text
Marciniec, A.; ...The Determination of Accuracy of the Demonstrator of Aeronautic Bevel Gearbox, Accomplished by Selected Rapid10.5604/12314005.1133210205-209Full text
Merkisz-Guranowska, A.; ...Possibility of Reducing CO2 Emissions for Example Electric Vehicles10.5604/12314005.1133215211-217Full text
Merkisz, J.; ...The Influence of the Driving Style on the CO2 Emissions from a Passenger Car10.5604/12314005.1133212219-226Full text
Miszczak, A.Structure Analysis of the Surface of Plunger and Barrel Assembly in the Injection Pump Pumping Section10.5604/12314005.1133219227-234Full text
Mitaniec, W.; ...Investigations of Engine Exhaust Gas Emission with Oxygen Enriched Mixture and High Exhaust Gas Recirculation10.5604/12314005.1133221235-243Full text
Molenda, J.; ...Measurements of Lapping Plate Temperature10.5604/12314005.1133224245-250Full text
Muślewski, Ł.; ...Analysis of the Change of Qualitative States of Transportation System Operation10.5604/12314005.1133218251-257Full text
Rumianek, P.; ...Polymers Foam Structure Numerical Identification10.5604/12314005.1133226260-263Full text
Smolarek, L.Container Terminal as a Queening Transport Networks10.5604/12314005.1133228265-270Full text
Stalewski, W.; ...Modification of Aerodynamic Wing Loads by Fluidic Devices10.5604/12314005.1133229271-278Full text
Wierzbicki, S.; ...Effect of Pilot Charge Size and Biogas Composition on the Operating Efficiency of a Dual-Fuel Compression-Ignition Engine10.5604/12314005.1133233279-284Full text
Wierzcholski, K.; ...Wear Process in Successive Time Units Described by First Order Recurrences10.5604/12314005.1133237285-292Full text
Witkowski, K.; ...The Issue of the Atmosphere Protection Against Toxic Compounds Gas Emissions in Maritime Transport10.5604/12314005.1133238293-300Full text
Wygodnik, P.; ...Criteria for the Assessment of the Engine Efficiency of the Multi-Purpose Aircraft Missions10.5604/12314005.1133241301-307Full text
Żurek, J.; ...Experimental and Numerical Modelling of Combustion Process of Liquid Fuels under Laminar Conditions10.5604/12314005.1134559309-316Full text